Wheels made in Ditherm® monolithic material, phenolic free
-40°C +300°C | -40°F +572°F
Enter Ditherm MTW seriesThe MTW series has replaced the old “phenolic” wheels, and is manufactured in special Ditherm® compound, combined with special fibers and molded under an innovative DC developed high pressure + extreme temperature process which results in the highest quality wheel in its range of application.
They are available with several types of hubs and bearings, in order to allow the perfect response and the best need / price ratio for any type of high or low temperature requirement.
The MTW wheels can be fitted into a specific series of brackets for high/low temperatures, which are specifically studied and produced to fulfill the extremely wide variability of conditions to which they are submitted in the world of uses in temperatures and bakery / food industry.
Brackets are fully certified and manufactured with food and sanitary grade Stainless Steel in AISI 304 / 316, and are available in both metric and inches standard sizes, and are also available in double-layer galvanized pressed steel.
They are RoHS - REACh compliant, and the permanent lubrication has been approved by FDA-USDA for contact with foods.
A computerized control of the swivel head ball race and assembling tolerances assures a perfect plate rotation without locking point.
Brake system is perfect for low and high temperatures and for inside-outside use and is maintenance free.
The DITHERM MTW wheels are manufactured to resist to a range of temperatures between -40°C and +300°C
They features a good resistance to water, most solvents, oils, acids and chemicals, excellent fire-smoke-toxicity properties and are fully certified for use in bakery and food industry, as well as for any oven application requiring temperature of exercise up to +300°C of peak.
These wheel assures also a great work into freezers and in temperature until -40°C and guarantee a high resistance against thermal shock caused by quick increasing or reduction of temperature, in fact the new Ditherm® material allow these wheels to resist to sudden variation of temperatures, permitting to withstand jumps of 340°C in less than 60 seconds, either from cold to hot or reverse.
Ditherm MTW wheels do not mark the floor when the free rolling is secured, but can leave traces of grinded material if used on abrasive floors ; also, some chipping or cracking of the wheel surface can happen in case of use on very uneven floors or in presence of heavy impacts against sharp obstacles, and in this eventuality we suggest you to contact our offices which will be able to provide the perfect wheel for your needs.
In compliance with the new rules effective May 2011, the “phenolic” word has been dismissed and will not be related to any of our high temperature wheels.
IMPORTANT NOTE :
The “phenolic” word is commonly used to identify the wheels that are similar to our series MTW, but because the phenolic material is not allowed to manufacture this type of wheel, the “phenolic” word has been replaced by “Ditherm” in all DC Di Candia Ruote literature.
